![]() ![]() ![]() Next, secure the paper bay in its previous state, pull off if there is any extra portion left from the paper roll, and bam! You’re good to go. Make sure the shiny side of the paper roll is up and the paper is feeding away from the screen of the terminal.Ĥ. Grab the paper roll and place it inside it.ģ. At first, pull the latch and open the paper bay of the terminal.Ģ. So, you don’t need to worry about changing inks but you do need to worry about loading new thermal paper rolls.Īctually, you don’t have to worry because we will tell you exactly about that.ġ. How To Change the Ink! (In other words, How To Load Thermal Papers) SSID: It’s basically the network name that you have to enter.Network Key: The network key is the network password that you will have to enter in this part.Security Type: It will be one of the following types- WPA1-TKIP, WPA2-AES or WPA1-AES.After that, you will get three segments that you will have to fill up and these are Next, enter the following password: 766130 or 990712ĥ. First of all, you will have to select the hammer and wrench icon.Ĥ. Let’s get to know how you can easily do that.ġ. Wifi: How to ConnectĪs a user, you may find it a bit difficult to connect it to the wifi network. After that, unplug the telephone wire from the blue port, wait for 10-20 seconds, reconnect those power and phone lines, wait for the network to establish and you’re good to go. ![]() Now that you know how to connect it to a phone line let’s get to know what you can do if there is a “phone line not connected” error shown. Then connect the power cable to the port of the power Adapter and don’t forget to replace the back cover of it after that. However, if you’re going with a telephone jack, put the other part of the cable into a telephone jack that is analog. After that, into a numbered port of the router, put the other part of the ethernet cable. Usually, ether cables are being used for a faster experience.ģ. There is an alternative, instead of going with an ethernet cable, you can use the cable which already comes with the package in the blue-colored port. Now you have to plug in an Ethernet Cable that you need to buy separately in the yellow-colored port. The first thing that you need to do is remove the cover from the terminal’s backside.Ģ. So, without further ado, let’s get to know how we can connect the phone line here. The phone line not getting connected is one of the most well-known issues that users face with their Fd130. 8 Wrap Up! First data Fd130 Troubleshooting – How to fix common Problems Phone Line Not Connected ![]()
0 Comments
Leave a Reply. |